Amps
[Top] [All Lists]

[AMPS] Mount pi-net capacitors vertically

To: <amps@contesting.com>
Subject: [AMPS] Mount pi-net capacitors vertically
From: Peter_Chadwick@mitel.com (Peter Chadwick)
Date: Mon, 18 Sep 2000 10:38:57 +0100
After getting the comments from Rich about this, I've gone over to vertical
mounting, and found (fortuitously?) that I end up with far more sanitary layouts
and easier mechanics. However, I am motor driving, so I don't have right angle
drives to worry about. Having said that, I got a whole load of bevel gears at a
hamfest this year for about 15 cents each, all with 6 mm holes in them. (Metric
gears, but that's no problem...)

The biggest difficulty is making sure that the connection to the front of the
vacuum variable capacitor is electrically good. I use an electrolytic capacitor
clamp to hold the cap, and a piece of thin copper sheet under the clamp to make
the connection. Because of inductance, this might not be too good at VHF though,
and possibly I need to make a proper collett out of aluminium - or brass - for
the new amp. However, in the antenna tuner for 160 and 80, there's no problem.

I guess if you're going mobile with one in the rig, vertical mounting has
advantages, especially if you're going off road - or in California, where
CalTrans seem able to make the best roads rough!

73

Peter G3RZP



--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>