Amps
[Top] [All Lists]

[AMPS] Zener screen supplies

To: <amps@contesting.com>
Subject: [AMPS] Zener screen supplies
From: g8gsq@qsl.net (Steve Thompson)
Date: Thu, 12 Apr 2001 09:13:55 +0100
A different aspect to consider - what happens when there is anode-screen
flashover. I inherited a PSU (with 10x33V/5W zener screen supply) from a
friend. A dud tube caused a flashover and lots of damage. After some
investigation, I came to the conclusion that 375V VDR clamps on the screen
didn't protect anything, as their clamping voltage at 10s Amps is around
600V+. The arc current went through the screen meter and shunt and down the
zeners, taking some of them and permanently damaging the meter and shunt.
Yes, there was a suitable 50 ohm resistor in the plate supply.

One advantage of an 'electronic' screen supply is that you can build in a
current sink limit and make the VDRs work for a living.

Steve


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>