Disconnect the hv from the 8875s, If it stops blowing fuses, the problem
is inside the tubes. To test the tubes for current leakage, use a
high-pot tester set to 5kV. Anything over 10uA-cold anode-grid is not
good news.
>My MLA keeps blowing fuses at power up.... It's done this before but
>"fixed" itself after a short bit. Not this time. Any suggestions? (other
>than buy a real amp.....)
>
>Blake N4GI
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
- R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
www.vcnet.com/measures.
end
|