[Amps] Re: Some suggestions...

[royanjoy@ncn.net (Roy Koeppe)]

Inquired,


"I am going to a swap this weekend.  I will be looking for some wire to
wind the plate choke in my new project.  What should I use?"  (etc.)

Modern #24 "enameled" is fine. Most are rated at least 1 kV or better,
so if you multiply the total turns on your solenoid choke by 2 kV
(side-by-side, double insulation) you'll see it's rated very
conservatively.

73,    Roy          K6XK/0