[Amps] Use of stainlees steel in RF environment

Amps

[Amps] Use of stainlees steel in RF environment

To:	<amps@contesting.com>
Subject:	[Amps] Use of stainlees steel in RF environment
From:	bmaser at tampabay.rr.com (Bob Maser)
Date:	Fri Feb 28 11:43:32 2003

I have been told by Amp building Elmer that it is highly unacceptable to use
stainless steel hardware in a RF enclosure.  I was planning on using SS
screws in many places in close proximity to the 3CX3000 that I am building.
He said that I should use brass only.  Is this correct?

Thanks, Bob W6TR

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
[Amps] Use of stainlees steel in RF environment, Bob Maser <= [Amps] Use of stainlees steel in RF environment, Phil Clements [Amps] Use of stainlees steel in RF environment, 2

Previous by Date:	[Amps] HV Filter Caps Source, 2
Next by Date:	[Amps] HV Filter Caps Source, Phil Clements
Previous by Thread:	[Amps] The red looking material, kd4lyh@bellsouth.net
Next by Thread:	[Amps] Use of stainlees steel in RF environment, Phil Clements
Indexes:	[Date] [Thread] [Top] [All Lists]