I've been using them for several years on my "universal" power supply to run
HV to two amps, one for 6M and one on 2M.
I've run as high as 6500 volts through them with no problem. I usually run
4200 volts.
I was not aware of the 5 KV rating!
73, Barrie, W7ALW
----- Original Message -----
From: "S. J. Blackwell" <w5lu@hotmail.com>
To: <amps@contesting.com>
Sent: Sunday, September 28, 2003 10:54 AM
Subject: [Amps] HN connectors
> Good morning,
> Does anyone have experience or advice in using HN connectors for HV in PS
on
> the floor to amp on the table via coax (RG214?)? Amphenol says they are
good
> for 5 KV.
> Thanks,
> Sam, W5LU
>
> _________________________________________________________________
> Get MSN 8 Dial-up Internet Service FREE for one month. Limited time
offer--
> sign up now! http://join.msn.com/?page=dept/dialup
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|