In the Philips/Mullard data book the
IM3 products at 30 MHz are quoted as -29 dB down from one tone
and IM5 -30 dB down.
The operating point quoted was 2200 V plate voltage, 300V screen voltage, 100
mA standing plate current,
and a PEP output of 320W per tube.
Normally PA designs with the 4CX350A used RF negative feedback to improve the
IM performance.
73/
Karl-Arne
SM0AOM
----- Original Message -----
From: "Steve Katz" <stevek@jmr.com>
To: <craxd1@ezwv.com>; <amps@contesting.com>
Sent: Wednesday, March 30, 2005 6:52 PM
Subject: Re: [Amps] [BULK] - Re: 4CX350 distortion products?
>
>
>
> Hmmm,
>
> I was thinking someone on here a while back mentioned it was the same tube
> but was beefed up a bit about the cooling. I dont have the spec sheet so was
> going on recollection. I've never used one in an amp so cant comment
> further. Thanks for letting me know.
>
> Best,
>
> Will
>
> ::Definitely very different tube from the 250 family. I've used the 4CX350F
> (26v version of the A) in several homebrew amps only because the tubes were
> readily available "new surplus" (JAN 4CX350F) for $10 each back in the late
> sixties, when I got them. Higher screen voltage requirement, different
> control grid bias requirement, and higher mu than the 250 family for sure.
> I could drive a pair of the 350s to 1 kW output on two meters with about
> four watts drive...-WB2WIK/6
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.308 / Virus Database: 266.8.4 - Release Date: 2005-03-27
>
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.8.4 - Release Date: 2005-03-27
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|