------------------------------
Dear Rich,
1. What anode voltage and current is your supply rated at?
It is a transformer I had originally planned to use with a 8877
class tube but got the deal on the 4-1000's, it has 3600v ac sec now fed
with a autotransformer and my high line voltage I can get 45000 ac no
load ,secondary is 18gage wire original at 1 amp CCS. 3 caps
100Mfd@2000vdc in series, 33Mfd@6000Vdc
2. What resistance and wattage bleeder did you go with?
6pc 50w 103k total ohms
3. Did you use a 200 to 400 watt, 25 ohm anode protection resistor? NO
4. Did you step-start the anode supply? Yes
5. Did you incorporate a HV shutoff with a vacuum relay? NO
6. Are you planning on using a vacuum variable TUNE capacitor to
withstand the HV?
I will later on if I can make it all work first with 40M monobander,
then add VV cap and B&W 850a ,now have a homemade variable cap.
7. Are you going to go with Grounded Grid or Grid Drive?
Not sure want to keep it simple for my first amp .
Rich, kd0zz
Questions, questions!
Thanks,
Hal Mandel
W4HBM
On Sun, 11 Sep 2005 11:34:37 -0500 "Rich" <rdjmgmt@socket.net> writes:
> Jack, if and when your get good information on a 4-1000 amp I sure
> could
> use a picture or two of the input/output relay set up, I have seen
> it on
> a schematic where the input is on the far left and the out put is
> always
> on the far right but can some one show this dummy how they look in
> real> life.,
> Rich, kd0zz
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|