I've owned a Ten-Tec Centurion (422B) for 2-1/2 years. Ten months ago,
its HV transformer developed a 1.5k ohm short between the two primaries
and was replaced by Ten-Tec (at my expense). Now the same thing has
again happened (and again it's a 1.5k ohm short). Both times the
step-start resistor fried as well. Amp is wired for 240V. Any ideas
what may cause this? Is it just plain bad luck?
Dan -- N3ND
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|