I need to make two panels and a baseplate for an amp. I could cut down 19"
panels but would like to find a cheaper way. Does anyone know what alloy of
aluminum is used for rack panels? I was thinking it was 6061 but I can't find
it in .125-inch thickness. The hardest I can find in that thickness is 5052.
This link compares them for hardness and machinibility:
http://www.smallparts.com/products/descriptions/sma.cfm
The baseplate is going to be about 17"x17" and has to hold a 33-lb transformer
and the rest of the amp, so it needs to be fairly stiff. I'd like the panels to
be stiff as well, especially the back, where I'll be hanging a heavy blower. Is
5052 okay? Thanks.
73,
Jim, KR1S
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|