Steve,
I have a cross match for HP2800 and HP2835 to NTE parts 112 and 484,
they are available locally. What characteristics should I look for? In
this circuit as long as they match will they work in this circuit?
73 Dan kb0qil
Steve Thompson wrote:
>
>
> Dan Sawyer wrote:
>
>> All,
>>
>> I have an 8405a with a bad probe. The unit makes it through most of
>> the calibration until the noise cancellation step. One board works
>> and comes in at less then 5 mv. However one shows a 1V peak to peak
>> distorted sine like wave. This probe actually works, however due to
>> the fault it has a phase frequency error. This error is of course
>> disaster for a phase meter.
>>
>> Does anyone have experience in diagnosing these probes?
>>
>> Does anyone have a lead as to what part to suspect?
>
> Usually it's blown from overload - the four diodes in the sampling
> gate and/or the p-channel fet go. There's a guy on ebay sells
> replacement kits. I haven't got round to repairing the one I have, but
> I reckon four shottky diodes from the same batch should work (HP2800
> or 2835, for example), and probably any general purpose p-channel fet.
> No promises on that, but it won't bankrupt you to try. As an
> alternative to four discrete diodes, I was thinking of trying one of
> the quad arrays you can get in a surface mount package.
>
> Steve
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|