Dan Sawyer wrote:
> Steve,
>
> I have a cross match for HP2800 and HP2835 to NTE parts 112 and 484,
> they are available locally. What characteristics should I look for? In
> this circuit as long as they match will they work in this circuit?
I think any small shottky diode will work in the circuit. Without
studying the manual, I'm not sure which characteristics matter most, but
at I doubt there's any need for precision matching, if you buy 4pcs in
one go, the likelyhood is they will come from the same batch and be
close enough. A while ago I repaired a damaged probe which had one blown
diode - I only had one to hand so I used it and the probe worked ok.
Later I put in a set of four the same, but didn't notice any difference.
Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|