There are three basic ways:
1. Bias them into cutoff and drive them into conduction.
2. Bias them normally and drive them into saturation.
3. A combination of the above.
Or are you looking for more than that?
73, Bill W6WRT
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
ORIGINAL MESSAGE:
At 04:58 AM 12/18/2005, cm215@greenwich.ac.uk wrote:
>Hiya Chaps,
>
>I am trying to build a non linear amplifier for a pre distorter amplifier
>however I need help on how to build a non linear amplifier that uses MOSFET's.
>
>Any ideas or links will be welcomed!
>
>Thanks
>Manish
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|