You don't really need a PCB (I assume that's what you meant). Just mount them
on a piece of plastic. Nearly any kind will do. Just space them apart and allow
room around them for the mounting screws. You can drill some holes and use
ordinary ground lugs to mount them. Many plastics will melt from the heat of
soldering, so do the soldering before screwing them down.
Should work fine.
Bill, W6WRT
>------- Original Message -------
>From : Ron Spencer[mailto:n4vos@bellsouth.net]
>Sent : 1/10/2006 9:48:06 AM
>To : amps@contesting.com
>Cc :
>Subject : RE: [Amps] Meter Res.
>
>Does anyone know where I can buy one or have a 5 Meg Resister I need one to
>go in a meter Circuit. I have 5 - 1 Meg but I don't what to make a PCP to put
>them on.
Ron Spencer
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|