Not quite true. The original Hercules I (model 444,
ran on 50V, not 12), is no longer supported, due to RF
transistor obsolescence. I have one on the bench
right now, fortunately the RF devices are fine, and
it's a power supply problem.
AFAIK, the Herc II (model 420) is fully supported.
Dave W8NF
>> Ten Tec Herc II? Runs on 12v, easy to drive (20w
will get you full
>> power, 25w on 160), give it a matched load and it's
happy.
> Caveat Emptor, the factory no longer supports this
amp; the transistors are
>no longer available.
> (((73)))
> Phil, K5PC
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|