Hello,
Needed a couple of knobs suitable for use with Groth dial
mechanisms. I have the Groth dial mechanisms other than the
knobs. Knobs with spinners are preferred. The knobs are for vacuum
variables in an almost finished GS35-B amp.
The knobs can be with either blank skirts or skirts that have marks
for the full 360 degrees. The skirts should be between 2 to 3 inches
diameter. The knobs should accept a 1/4 inch shaft.
73,
Mike, K4GMH
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|