Amps
[Top] [All Lists]

Re: [Amps] Future Amp Buyer Questions

To: <vtnn43e@comcast.net>, "Amps Reflector " <amps@contesting.com>
Subject: Re: [Amps] Future Amp Buyer Questions
From: "EP Swynar" <gswynar@durham.net>
Date: Sun, 26 Aug 2007 13:08:37 -0400
List-post: <mailto:amps@contesting.com>
Hi Zack,

My best advice for you would be --- first, and foremost --- to READ as much
about RF amplifiers as I could, from any & all sources, BEFORE deciding upon
which one to buy, or (heaven forbid!) which circuit / tube(s) to use in a
homebrewed creation...

With just that latter option in mind, the three part Bill Orr (W6SAI)
series, which was featured in the late 70's HAM RADIO magazine, would
certainly be a good place to start, IMHO.

~73!~ Eddy VE3CUI - VE3XZ

*****************************

----- Original Message ----- 
From: <vtnn43e@comcast.net>
To: "Amps Reflector " <amps@contesting.com>
Sent: Sunday, August 26, 2007 12:39 PM
Subject: [Amps] Future Amp Buyer Questions


I am seriously considering buying an amp in the very near future.

My antenna will be a Steppir BigIR & 80 meter coil both of which are
currently on order. Wish that I
could put up a beam but it is impossible in my circumstances (money, trees,
XYL, etc). The rig will be
a Flex-5000, also on order. Currently I have a Bencher YA1 low pass filter
inline along with a
LP-100 digital wattmeter from N8LP.

BTW I am leaning towards the Ameritron AL-811 or Al-811H mainly based on
price and reviews on
eham.

One of my reasons for wanting an amp is that the rig I am getting will only
put out 45 watts on RTTY.
Another is wanting that extra power for times when 100 watts on CW or SSB
will just not cut it.
However I don't expect it to be a miracle worker with a vertical.


Anyways here are my questions.

Are there any other amps in this price class that you would suggest?

If the amp is turned off can I transmit through it or is some external
switching needed? If it is in
standby can I transmit through it without utilizing the amp?

Are there any good instructions on using a AL-811(H)? on the web? The manual
from Ameritron is
kind of minimal.

Does anyone on the list have any good tuning or usage tips for these amps?

Is there any advantage to using the AL-811H on 220VAC?

Are there any accessories that I really should get? Are pulsers worth it?
Which one would you
suggest getting?

Any information on the above will be greatly appreciated!

73
Zack
N8FNR


----------------------------------------------------------------------------
----


> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>