The application is to ham radio related stuff. Not commercial. I do not know
what I may need to test in the future, so I do not know what to get in a tester.
john w9zy
Steve Katz <stevek@jmr.com> wrote:
What's the application?
A lot of off-the-shelf hipot testers for consumer electronic equipment
stop at 6kVdc (because that's the limit of the requirement for
compliance testing on a 240V circuit) and that's not nearly high enough
voltage to test, say, a high power transmitting tube.
Are you looking to do compliance testing, which requires a stipulated
ramp time, dwell time and leakage limit? Or just to see where stuff
flashes over? How high a voltage?
WB2WIK/6
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|