Hello,
This question could not have come at a better time. I am currently trying to
do the same thing with a plasma cutter I purchased this weekend. It turns
out the unit I thought was 220v single phase was actually 460v 3 phase. The
transformers are the same 3 bobbin type. I found this page that explains
some of it, but I am still trying to find the best way to run these
transformers from 220v single phase.
http://www.basler.com/downloads/3phXfmrs.pdf
Take Care,
Keith Spainhour, KT4XW
> I'm sure I should know the answer to this, but just can't seem to find
> anything in my literature or on the web. A friend (G7ODR, cc'd on this
> email) and I have scratched our heads, but the more we discuss the
> problem, the more complex it becomes.....
>
> If I use a 3 phase transformer (either a 380v or 415v primary) on a 240v
> single phase power supply, then what will happen in the secondaries?
>
> I think the transformers that I have access to are delta input and star
> output. They're open 3-bobbin jobs rather than potted or enclosed.
>
> Can I wind the secondaries in series without overloading the insulation?
> Could I wind them in parallel? Would I hit core saturation problems?
>
> So, to put a few figures on it, if it's a 12kva 3 phase 380v in, 6kv out,
> what would happen with the various permutations if I try to wire it onto
> 240v single phase?
>
> I'm actually looking for 4.5kv RMS out at 10kva and can get a single phase
> one custom wound, but at a price (£950 from TEC). Anyone in the UK know of
> a cheaper but quality source?
>
> Phone a friend, ask the audience etc.... ;-)
>
> Any ideas appreciated.
>
> cheers
>
> Dave G0OIL / K2MOO
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|