Ha ha. Try 7.1V for the AL-811H.
No wonder there's such a good market for 811A and 572B tubes here in Australia.
73, Alek
VK6APK
At 12:53 AM 26/06/2009, donroden@hiwaay.net wrote:
>I think it is more important to keep filament voltage at or below 6.3vac.
>Before modification, mine on a 30L-1 was over 6.9 standby and 6.7 under load.
>
>Don WA4NPL
>
>
>
>
>Quoting Roy <royanjoy@ncn.net>:
>
> > Svetlana states its 572B has getter on the plates. Needs only to
> be operated
> > under power.
> >
> > 73, Roy K6XK
> >
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
http://www.qrz.com/vk6apk
http://www.qrz.com/vk6py
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|