Hi Lon,
I have run a pair of AL1200's here for more than 20 years, both have
the internal QSK boards and the amp does NOT have to be on to use
the transceiver ... the QSK boards are two different 'generations' ...
and have been used with several makes/models xcvrs over the years.
Not sure why yours is requiring the amp to be ON ...
73 de Billy, AA4NU
-----Original Message-----
>From: kingwood <k5jv@kingwoodcable.com>
> It should be mentioned that when using the internal QSK-5PC, this
>situation never occurs because there are no relays involved. However, there
>are other issues. With the internal board, the amp must be turned on or no
>signal will pass through the QSK board to the receiver. Perhaps, that is
>why the relays were added to the stand alone unit?
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|