Hey Gerald,thanks for the info...I do have a drill press but prefer a lathe for
more precise fit...Larry,W7IUV has a bushing(And a lathe) and he`s only a 30
minute drive away so I think I`ll bug him!Thanks everyone for the
replys!...73..Jim..K7RDX...
----- Original Message -----
From: TexasRF@aol.com
To: k7rdx@charter.net ; amps@contesting.com
Sent: Monday, October 05, 2009 7:22 PM
Subject: Re: [Amps] Need bushing
If you have a drill press and vise, you can make one in a few minutes. A one
inch section of a .75" bolt makes the donor material. Drill through the center
.25" and then drill again half way .375" diameter. Set screws can be added by
drilling one side and tapping 6-32 or 8-32.
A .25" bolt and nut makes a nice mandrel to chuck the piece in the drill
press for smoothing the ends and removing burrs.
73,
Gerald K5GW
In a message dated 10/5/2009 8:34:26 P.M. Central Daylight Time,
k7rdx@charter.net writes:
Ampers: Looking for a bushing to adapt 3/8"shaft to 1/4"...Needs to be
solid not a flexible coupling..If anyone has such and will part with it please
contact me off list..Many thanks..Jim..K7RDX..
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.409 / Virus Database: 270.14.4/2416 - Release Date: 10/05/09
18:23:00
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|