Hi Bill,
I am a bit confused on this.
It's been a while - but I was thinking that I read one time on RM's site
about creating an intentional parallel resonance on the filament choke.
That's a different part, but it seems the principle would be the same.
73/jeff/ac0c
--------------------------------------------------
From: "Bill, W6WRT" <dezrat1242@yahoo.com>
Sent: Tuesday, October 13, 2009 11:03 AM
To: <amps@contesting.com>
Subject: Re: [Amps] Checking Plate Choke resonance
> ORIGINAL MESSAGE:
>
> On Mon, 12 Oct 2009 23:17:39 -0700, "Hardy Landskov" <n7rt@cox.net> wrote:
>
>>Sweep
>>the frequency range you want to use and watch for series resonances.
>
> REPLY:
>
> Watch for parallel resonances too. Either one will smoke the choke if they
> are
> in or near a ham band.
>
> 73, Bill W6WRT
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|