carl is right
simple 813's.. and 4-400's in GG will work just fine.
One can always 'up- grade' to Chinese 3-500Z later on... [ or a
3CX-1200] That socket will handle 4-400A/B/C 3-400Z and 3-500Z
3CX-1200 etc.
Even a SINGLE 4-400A/B/C would be a good ticket. Then u don't have to
worry about tube balancing problems etc.
keep the voltage down, then no vac tune cap required. If u can find a vac
tune cap, great, use it.
They are easy to get going on the low bands... and with some minor tweaking,
upper bands too.
Anything from 2-4 kv will work. The builder can up grade any portion of
it.. at any time. .. like qsk, etc.
Sorta like a ... 'work in progress' / starter amp / building experience.
/ learning experience.. all at once.
My buddy did that with the green lee large meter punch's....... bought em on
ebay .. used em.. then resold em !
later....... Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|