I am presently using a homebrew decoder for my Kenwood TS950 to read the RS232
data (using a STAMP chip) and setting the proper outputs (multiple "IF"
conditions on reading the RS232 data) to drive my antenna relay box.
Its getting buggy after many years and I don't want to revisit the R & D
project it was to find out the bug why its sometimes doesn't read the data
right. I am assuming the 950 is always reading it correctly as only one of 9
bands occasionally doesn't close. It could be the relay driver but as I said, I
am not in the R & D mood anymore HI
I am looking to dump the decoder I have but I don't see much out there with the
possibility of a box by microHAM
http://www.wimo.com/cgi-bin/verteiler.pl?url=antenna-switch-microham_e.html
Anyone know if this unit can switch antenna relay without the use of a PC? If
so has anyone ever used one? Is there another decoder I am not aware of for the
TS950?
Thanks in advance
73
Jay
W2IJ
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|