Personaly , I would just isolate the power transformer and test it out of
circuit , once it is eliminated as a problem work back
......................................................................................................
73 VE3DV , Dave
> From: k9mk@flash.net
> To: amps@contesting.com
> Date: Thu, 7 Oct 2010 08:22:41 -0500
> Subject: [Amps] Heath SB1000 blowing fuses, fault finding suggestions.
>
>
> I'm working on a SB1000 from an estate that sat idle for maybe a decade,
> and prior to that it had little use. Last known it was working but now it
> is blowing fuses...
>
> I have pulled both HV secondary wires off the rectifier board and also
> pulled the wires from LV secondary. To be safe I also removed the tube but
> the amp still blows the fuses.
>
> As I am working back to the AC plug it's starting to look like the power
> transformer is shorted in some manner. But I have never seen one go bad
> before from "sitting idle". The only other element to isolate is the
> AC-main on-off relay. So I'm thinking that the problem is either a fault in
> the AC Mains relay when it engages or some fault in the power XFMR.
>
> Has anyone here chased a similar problem before? Is there a simple way
> to confirm one or the other?
>
> Thanks in advance for your thoughts and comments.
>
> 73's Mike K9MK
>
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|