If the corona was due to circuit design dont blame the switch.
I was also going to suggest insulating it from ground as would be done in a
bigger amp but the OP only has some 2500V tubes.
Carl
KM1H
----- Original Message -----
From: "Vic K2VCO" <k2vco.vic@gmail.com>
To: <amps@contesting.com>
Sent: Monday, February 06, 2012 10:58 AM
Subject: Re: [Amps] BC-375E Switch
> They are good for high current, but not so much for high voltage. I
> replaced one in a
> friend's 4-1000A amplifier after it was damaged by corona-induced arcing.
> The amp was
> running at 3600v.
>
> On 2/6/2012 5:41 AM, Carl wrote:
>> Its fine at that low power, just give it a good dishwasher cleaning to
>> get
>> rid of 70 years of gunk on the ceramic.
>>
>> Carl
>> KM1H
>>
>>
>> ----- Original Message -----
>> From: "John Finner"<finnerjf@att.net>
>> To:<amps@contesting.com>
>> Sent: Sunday, February 05, 2012 10:24 PM
>> Subject: [Amps] BC-375E Switch
>>
>>
>>> How stout is the BC-375E switch? Is it suitable for band switch use in
>>> my
>>> 3 4CX300A tube amp at 1800 watts input?
>>>
>>> John WA4EPI
>
> --
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco/
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2112/4792 - Release Date: 02/06/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|