If you grab a GS35b or GS31b and have a close look at the way it is
constructed, you'll see that the use of a soldering iron on the
heater/cathode connection points will not damage the tube or the seals
in any way.
Soldering those wires on there is as simple, economical and effective as
it gets. One could argue that doing it any other way is silly overkill.
73, Alek
VK6APK
On 1/08/2012 9:03 AM, Carl wrote:
> ----- Original Message -----
> From: "Bill, W6WRT" <dezrat1242@yahoo.com>
> To: "AMPS" <amps@contesting.com>
> Sent: Tuesday, July 31, 2012 7:22 PM
> Subject: Re: [Amps] 3CX1500A7/8877 vs el cheapo GS-35B
>
>
>> ORIGINAL MESSAGE:
>> On Tue, 31 Jul 2012 15:27:13 -0400, you wrote:
>>
>>> Fancy machine work, solder the filament leads to the tubes!
>>>
>>> Carl
>>> KM1H
>> REPLY:
>> How would you do that without exceeding the seal temperature?
>>
>> 73, Bill W6WRT
>>
>
> Ask Dr Alex, I was just looking at a photo of a 2X GS-35B amp.
>
> Carl
> KM1H
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
--
http://www.qrz.com/db/vk6apk
http://www.qrz.com/db/vk6ap
Family Businesses:
Petkovic Air & Gas. petkovicag@bigpond.com
SP Electrical. www.spelectrical.net.au
Hampers by Hand. www.facebook.com/hampersbyhand
=======
Email scanned by PC Tools - No viruses or spyware found.
(Email Guard: 9.0.0.2298, Virus/Spyware Database: 6.20260)
http://www.pctools.com/
=======
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|