Hi Vic,
If you can measure the cross section of the laminations (center post or sum
of the side posts) there are old charts (i.e. 1976 ARRL Handbook, Transformer
Rewinding, p.109) that show the power capability of old transformers.
A data point: 1-1/4 square inches is good for 50 watts as I read it.
73 & Good morning,
Marv WC6W
http://qsl.net/wc6w/
--- On Sun, 8/26/12, Vic K2VCO <k2vco.vic@gmail.com> wrote:
> From: Vic K2VCO <k2vco.vic@gmail.com>
> Subject: [Amps] Transformer guess?
> To: "Amps reflector" <amps@contesting.com>
> Date: Sunday, August 26, 2012, 1:20 PM
> I have a small power transformer
> here, Philco 45-7011-7, which I would like to use for a
> screen supply. It has the usual center tapped HV winding,
> which measures 380-0-380v, just
> right, as well as 5v and 6v filament windings.
>
> What I want to know is how much DC I can draw from the HV
> winding with a full-wave CT
> circuit. Googling the number reveals a similar, but smaller
> transformer rated at
> 350-0-350v at 40 mA, the 45-7011-1. This one is bigger so I
> am hoping it will be capable
> of more current.
>
> The transformer weighs 3 pounds 10 ounces (1.63 kg). The
> lamination stack measures 3-3/8"
> x 2-7/8" x 1-1/2" (8.57cm x 7.3cm x 3.8cm).
>
> Can one of the transformer gurus hazard a guess as to the
> current capability? I'm hoping
> for 75 mA.
>
> --
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco/
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|