Hello all,
Want to re-do the input matching of an old HB 8877 amp. What should I use for
the cathode impedance when calculating my pi network? I recall it was
something like 50-60 ohms.
Also, thinking attenuating the drive power AFTER the T/R relay and before the
matching network. Right now it only takes 22 watts for 1500 out at 4 KV. A
bit touchy to tune (only been like that for 27 yrs.) Would be nicer to tune at
60, or so, watts out. I saw where Henry radio has some attenuators on Ebay
that might fit the bill.
http://www.ebay.com/itm/New-250-Watt-4-dB-50-ohm-Hybrid-Attenuator-up-2-GHz-/390408415503?pt=LH_DefaultDomain_0&hash=item5ae627a90f
Comments?
73 de Steve, NR4M
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|