Amps
[Top] [All Lists]

Re: [Amps] Amp Supply LK500ZB - strange failure mode

To: "Alek Petkovic" <vk6apk@bigpond.com>, "Amplifier Mailing List" <amps@contesting.com>
Subject: Re: [Amps] Amp Supply LK500ZB - strange failure mode
From: "Jim W7RY" <w7ry@centurytel.net>
Reply-to: Jim W7RY <w7ry@centurytel.net>
Date: Thu, 2 Oct 2014 21:44:08 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Agreed!
73
Jim W7RY


-----Original Message----- From: Alek Petkovic
Sent: Thursday, October 02, 2014 8:25 PM
To: Amplifier Mailing List
Subject: Re: [Amps] Amp Supply LK500ZB - strange failure mode

See http://www.rfconcepts.com/PRODUCTS/tubes

They appear to be the best deal around.

73, Alek
VK6APK

On 3/10/2014 10:05 AM, k0zx Rich wrote:
Right you were Colin. After pulling and swapping the result was one of them had the symptom and the other didn't. Pretty clear cut. So I guess I'm on the hunt for another, first price i've seen was 189, hoping can do better than that. Thanx for the suggestion, I got focused in on possible semiconductor failure, replaced the zener in the cathode path.
Are u and owner of one of these amps?
rich


On 10/2/2014 9:07 AM, Colin Lamb wrote:


Hi Rich:

Pull one tube and try it - then the other.  I suspect one tube.

Tuning will change and the input swr will increase - but you are looking for an obviously bad tube.

Assuming the filaments are not in series and the cooling is not solely through the socket, it will fire up fine. Watch out for hv bite.

73,  Colin  K7FM


On 10/2/2014 7:59 AM, k0zx Rich wrote:
Wonder if anyone has experienced this failure mode with this or a similar amp:

This amp is 80s vintage and since then has been a solid performer, grounded grid with two 3-500z. But it has a developed a problem where at power up (no rf drive, ant relay input not active for tx), the plate current rises to about 3x normal (about 300ma, 100 is normal), stays there for 5 to 10 seconds and then drops to zero. If enabled to transmit with antenna relay input on, plate idle current is normal, going from 0 to 100ma. If apply rf in, it will output but at only about .6 or .7 its normal output. After inspecting the schematic am not seeing an obvious source for the problem.

Any suggestions appreciated
Rich
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


--
From Sunny Binningup


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>