Re: [Amps] titan 425 low output power

[Mark Robinson <markrob@mindspring.com>]

Yes that is a good thought.  My 425 makes about 1kw with 20 watts or so.


Mark N1UK


> On 04-May-15 8:51 PM, Riichard Neuman via Amps wrote:
> > sure you didnt hit the HI-LO VOLTAGE switch on power supply while 
> > reinstalling?
> > 73,
> > Richard
> >
> >
> >
> >
> > -----Original Message-----
> > From: CenturyLink Customer <idahogn@q.com>
> > To: amps <amps@contesting.com>
> > Sent: Mon, May 4, 2015 8:14 pm
> > Subject: [Amps] titan 425 low output power
> >
> >
> > hello all,
> >
> >
> > i have a titan 425 that was returned by tentec ( 700 dollar
> > repair bill) with a clean bill of health ( had a wafer switch 
> > replaced) when
> > taken out of the box the amplifier will only make 1000 watts pep with 
> > 100 watts
> > of drive. i use to make 1000 watts with 20 watts worth of drive. 
> > thought a tube
> > got damaged. replaced with new eimacs and it does the exact same 
> > thing. any
> > ideas on what could be wrong? this is the second and last time i will 
> > use
> > tentec. not a good experience.
> >
> >
> > where should i start?
> >
> >
> > shawn
> >
> > _______________________________________________
> > Amps mailing
> > list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> >   _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps