In the early days, we just used a Diac in a simple circuit. No big pulse
and no series of pulses. Once the threshold was reached, the SCR was in
control of the rest including how fast it turned on. We weren't
interested in noise there, but we did have some sensitive measuring
circuits on the "other side of the creek"
For most hams, building a circuit using SCRs, or Triacs to control
voltage is a great way to do a step start. It easily ramps up the
voltage. My amp does that, but any receiver in the room sounds like
someone zipping up a ski jacket. As it's less than 2 seconds. Who
cares. OTOH running all the time to control the input to a transformer?
No Thanks. Getting them quiet? It's well beyond most hams, either in
knowledge, or patience.
73
Roger (K8RI)
On 8/20/2016 Saturday 6:35 PM, Manfred Mornhinweg wrote:
Paul, and all,
The gates of SCR's need to be pulse fired for reliable phase
control. Commercial units have pulse train burst applied to the
gates through a pulse transformer. The phase angle of the burst is
derived any number of ways which can be very precise and repeatable.
It just takes some op amps and in some cases a few logic ICs, or a
special function IC, to obtain to control signals.
Back in the age when SCRs were high in fashion, unijunction
transistors were also fashionable, and many SCR circuits of the day
used UJTs to generate the gate trigger pulses.
In my own SCR and TRIAC circuits I never used UJTs, though. Instead I
either generate a nice trigger pulse using a DIAC behind a capacitor,
or I trigger the devices with a long pulse, often as long as 1ms,
generated by logic ICs, op amps, or more commonly a microcontroller.
Reasonably modern SCRs have trigger currents below 50mA, often far
below, which is low enough that 1ms pulse length isn't a big waste of
energy. When one has to trigger a device at the zero crossing, such a
long pulse is very useful, because one can start the pulse right at
the zero crossing, it will turn on the device, AND hold it on until
the current has risen enough to keep the device on for the remainder
of the semicycle. With old SCRs that required several amperes to
trigger, a similar effect was achieved with a train of narrow pulses.
When the load is inductive, current will ramp up at a certain
(possibly low) rate even when the device is triggered in the middle of
a semicycle, so the long trigger pulse, or train of short pulses, is
often required anyway, with the single long pulse being safer.
Manfred
========================
Visit my hobby homepage!
http://ludens.cl
========================
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|