I forgot to say MFJ also said the SAF-T-EZ is kind of thick, so they mix
a little 10W40 oil with it to thin it.
73
Stan
KM4HQE
On 08/01/2018 10:32 AM, Carl wrote:
Why not contact MFJ who builds theirs as well as Oren Elliot Products
plus Multi Tech Industries who builds "big" ones.
Carl
----- Original Message ----- From: "Stan Gammons" <s_gammons@charter.net>
To: <amps@contesting.com>
Sent: Sunday, July 29, 2018 11:29 PM
Subject: Re: [Amps] Lube for roller inductor
On 07/07/2018 01:05 PM, Bert wrote:
I don't think Penetrox is a good idea for a roller inductor. As far
as I know, Penetrox is only conductive if put under pressure.
I would suggest one of the CAIG DeOxit products, e.g. DeOxit 5.
Bert VE3NR
Kind of reviving this thread since I have a roller inductor that was
acting a bit flaky, so I took it out and gave it a good cleaning in
my ultrasonic cleaner. No lubes left on it now and it's very clean.
So, what is general consensus, DeOxit D5 is Ok to use to use on the
roller? Unsure how much of a lubricant it is, but I know it's a great
contact cleaner.
73
Stan
KM4HQE
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|