When AlphaRemote's frequency was jumping all over the place, were you
transmitting? If so, I'd suspect something wrong with the frequency detector or
a loose connection or bad component in the RF path to it. If you weren't
transmitting, then I'd suspect something is going on with the RS-232 interface
-- maybe noise on it or something. Another possibility is that your computer is
sending garbage to the amp on the RS232 interface. You could try unplugging the
RS-232 interface to see if that fixes the problem.
If it doesn't have anything to do with RS-232, then I'd suspect maybe the
stepper motors aren't moving the tune and/or load caps to the proper positions.
I've seen that happen a few times. The solution is usually to exercise the caps
by hitting alternate segment buttons to move them from one end of their travel
to the other. A few times back and forth usually deals with "sticky" caps.
If that doesn't fix the problem, try returning all segments to factory default.
See if AlphaMax behaves then. If not, turn off AlphaMax and see if you can
manually tune a segment for a particular antenna. If that goes OK, see if the
tuning is OK after you QSY and come back to that segment. If it's OK, try
AlphaMax again. If it's not OK, something is going on with the memory or with
the stepper motors.
Note: a steady carrier helps AlphaMax find the tuning solution better than CW.
Finally, it could be the CPU. Was there any lightning in the area lately?
Lightning damaged my 87A CPU, though it only killed the TTL pin that connected
to the RS-232 level converter. Otherwise, the amp worked fine. If a small surge
hit your amp, maybe it screwed up the serial communications. You can check that
by connecting with a terminal program and issuing some commands, like SF and HF
to dump soft and hard faults. If all that looks clean, the RS-232 is probably
OK.
73, Dick WC1M
-----Original Message-----
From: Michael Tope <W4EF@dellroy.com>
Sent: Sunday, May 26, 2019 1:55 PM
To: amps@contesting.com
Subject: [Amps] Alpha 87A Problem
My Alpha 87A had been working pretty faithfully up until the end of March /
early April. I haven't used it since then until this weekend.
Normally I operate remotely, but this weekend I had to come up to my remote
site for something else, so I decided to play a little bit in the CQ WPX CW
contest. I noticed right away that the tuning on the 87A seemed squirrely on 40
meters (the amp kept re-tuning even thought I wasn't changing frequency and
VSWR appeared stable). When I moved higher in the band to call CQ it seemed to
settle down and was delivering a steady 1300 watts.
This morning I tried operating 20 meters. At first when I was calling people
low in the band, the amp seemed okay, but when I went higher in the band, it
started acting up where it kept hunting for a new tuning solution and in some
cases it would fault. After a little fiddling, I noticed that the frequency
readout on the Alpha Remote software was jumping all over the place (in some
cases up to 16.3 MHz!!). In one case, because of the faulty tuning, I noticed
that the grid current reading was really high, but the grid trip circuit didn't
protect the amp.
Any ideas where to start? Seems like it might be a microprocessor problem. When
it is stable, the amp is making plenty of power (1300 to
1500 watts).
Reducing drive, doesn't seem to help, so I don't think it is an RF in the shack
problem. I would put it on a dummy load, but my Cantenna is 60 miles away at my
home QTH (next trip up I will bring it).
73, Mike W4EF...................
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|