Yes, it could be at VHF or even LF.
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CWops no. 5
http://www.qsl.net/k2vco/
On 24/05/2023 15:42, Ken Harada wrote:
Then my wiring is not good? But I don't hear noise on a receiver beside
the amp - though I should watch different frequency to detect...
On 2023/05/24 21:39, Victor Rosenthal 4X6GP wrote:
Perhaps it's breaking into oscillation?
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CWops no. 5
http://www.qsl.net/k2vco/
On 24/05/2023 15:20, Ken Harada wrote:
Hi Amp enthusiasts,
I am building a HF linear amp with 2 x 4CX350A with cathode driven
circuit, but getting a strange symptom. Ep=2000V, Esg=300V
(regulated with Zener and FET), Ecg=-50V to -20V (by LM337SP). Before
applying any RF, I try to adjust no signal anode current by varying
the Ecg. Going up from -40V, it gradually increases from 0 to approx
50mA, and in a sudden it jumps up to 300mA (around at -30V). Moving
back to deeper Ecg, it remains 300mA and suddenly drop to 0 - showing
hysteresis.
I wonder what is happening to the tubes/circuit and where I should
check. Any suggestion would be greatly appreciated.
Regards,
Ken /JO1VRK
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|