My guess. Icom has 8V on the mic line to drive preamps, since they decided
not to put them in the radios :-(. Need a DC blocking capacitor in line.
Forget the value, but want to pass voice and block DC. Should be referenced
in the manual, or on the web all over the place.
Dan KI6X
-----Original Message-----
From: cq-contest-admin@contesting.com
[mailto:cq-contest-admin@contesting.com]On Behalf Of Jaime Robles
Sent: Wednesday, September 18, 2002 2:56 PM
To: cq-contest@contesting.com
Subject: [CQ-Contest] Heil from Kenwood to Icom
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hello all!
As i have changed my old TS-50 for a IC-7400 i would like to use my heil
with
it.
Could anybody tell me how to "remake" the connection, please?
I have rewired the mic conector as said in the IC manual... so
Kenwood Icom
1 1 MIC
2 5 PTT
7 7 GND
8 6 GND(mic)
When i connect this to my new rig (the ic) i can change between rx/tx but no
signal goes to the air... no voice, mic signal is not working...
Any idea?
Thanks.
- --
Un saludo,
Jaime Robles, EA4TV
jaime@robles.nu
Visita http://www.redlibre.net - La Red Libre de todos!
http://smsdx.net - El DXCluster en tu movil!
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.7 (GNU/Linux)
iD8DBQE9iPZWER46oL+8yYURAnyVAJ9+R0gCqedQTKGbnHm48pUSL0YQ5wCeOMMk
KilHtz3Z77+uDfzJc3bwtzc=
=OJXF
-----END PGP SIGNATURE-----
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|