Hi Tom,
Yes, I have an MFJ analyzer as well and it will work just great.
1) Set you analyzer for 14.200 Mhz
2) Use good quality coax. RG-8 is OK, RG-213 is better. The better the
coax the steeper the null
Due to the higher 'Q' of the coax.
3) Short the ends together. Trim off a few inches at a time and short the
ends. Look at the
Reactance value (Xs or X on the analyzer.). When this value is 0 you
are good to go. Ignore
the SWR or impedance values. Reactance of zero is what you are after.
Good luck and 73's
Guy, N7ZG
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|