CQ-Contest
[Top] [All Lists]

Re: [TowerTalk] newest bestest radial material ever!

To: K1TTT <K1TTT@ARRL.NET>
Subject: Re: [TowerTalk] newest bestest radial material ever!
From: "Richard (Rick) Karlquist" <richard@karlquist.com>
Date: Fri, 17 Aug 2007 08:10:40 -0700
List-post: <mailto:towertalk@contesting.com>
Last year I bought some aluminum wire in coils like you describe.  I 
think it was a company
in Ohio and may very well have been Malinco.  Anyway, they had a 50 lb 
minimum and charged
something like $3 and change per pound.  This is way cheaper than 
McMaster.  I wholeheartedly
agree that alloy 1100 is the hot setup.  BTW, did you know it also is 
the most corrosion resistant?
The stuff I got was annealed to practically wet noodle consistency :-).  
Wonderful to work with.

Rick N6RK



K1TTT wrote:
> I just found the newest bestest radial material I have ever used!  And over
> the years I have used a lot of them.  It ain't cheap, but at this point in
> the 80m 4-square project that doesn't much matter any more.  
>
> It is Alloy 1100 Aluminum Wire .125" Diameter(just under 8ga), 12-lb Coil,
> 792' Coil, McMaster-Carr part number 8866k15.  They sell it for $150 and its
> enough for 12 radials for 80m.  it comes with a tag from www.malinco.com,
> they don't seem to have an on-line order system so probably only deal in big
> quantities.
>
> If you want something a bit cheaper they have 2016' coils of .080 (about
> 12ga) for $146.
>
> This stuff comes in a coil, which kind of worried me a bit until I cut off
> the tie wraps and it just sat there... no spring to it at all.  It is easy
> to cut with small wire cutters, and easy to hand wrap around bolts and
> itself to make eyes.  It can also be uncoiled and doesn't get kinked, you
> don't have to roll it out like Copperweld or other stiffer wires.  I found
> it easiest to just stick the coil over one arm and uncoil it as I walked
> from vertical to vertical to connect them up.  
>
> Btw, even with just the radials connected around the square this new
> 4-square is MUCH better than the old hanging around a tower.  I can take an
> s9+ ve3 and make them disappear off the back.
>
> David Robbins K1TTT
> e-mail: mailto:k1ttt@arrl.net
> web: http://www.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
>  
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>   

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>