you will need switch to switch stubs between 20 15 and 10!
when you messure (optimize) your stubs you have to do that trough switch!
technical refernce from K1TTT site will help you to chose stubs you need!
you will need stubs on both anetnnas!
73
de oe1ems
braco
----- Original Message -----
From: "Jim Rhodes" <k0xu@longlines.com>
To: "Filipe Lopes" <ct1ilt@mail.telepac.pt>; <cq-contest@contesting.com>
Sent: Saturday, November 10, 2007 6:27 AM
Subject: Re: [CQ-Contest] Coax Stubs with Tribanders
> K1TTT has some references on his site:
>
> http://www.k1ttt.net/technote/techref.html
>
> Under the heading "Filters"
>
>
> At 03:48 PM 11/9/2007, Filipe Lopes wrote:
>>Hi,
>>
>>Can anyone help me with some scheme/measurements for stubs using
>>tribanders?
>>
>>I have 2 towers with tribander and 3 elem quad but they are very close and
>>I
>>have some interference in some directions. Anyone can help me ?
>>
>>
>>I would like to try the stubs for CQWW CW...
>>
>>73's Filipe Lopes CT1ILT aka CT6A 6Y3T
>>
>>
>>_______________________________________________
>>CQ-Contest mailing list
>>CQ-Contest@contesting.com
>>http://lists.contesting.com/mailman/listinfo/cq-contest
>
> Jim Rhodes K0XU
> jim@rhodesend.net
>
> Experience is the thing you have left when everything else is gone.
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|