Gang-
I am on my 2nd Yaesu 450a rotor, in the past 4 years. The rotor is fine, the
control box has issues. Here is what I see:
Indicator seems to work fine, going from due south, clockwise, until it gets
about 300 degrees. then it seems to stumble, and, stops at 90 degrees east.
The rotor rotates the whole 360. The problem isn't with the rotor, as I
have 2 rotors, and both act the exact same.
Could it be the pot in the box, or the little motor that drives the
indicator needle? I would guess I'm not the only one who has had this issue,
any
comments, or ideas?
Thanks
73- Chuck KI9A
**************A Good Credit Score is 700 or Above. See yours in just 2 easy
steps!
(http://pr.atwola.com/promoclk/100000075x1215855013x1201028747/aol?redir=http://www.freecreditreport.com/pm/default.aspx?sc=668072%26hmpgID=62%26bcd=De
cemailfooterNO62)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|