I noticed that stations that didn't ID often usually had several people
(including me) asking for their calls. This has to slow things down. Many
worked them and then asked for their call. I can understand only IDing
every second or third QSO if you are over a 200/hr rate. That gives a few
weaker signals a chance, but not waiting a minute or two!
Chuck W5PR
On Tue, Mar 8, 2016 at 1:10 PM, Jeff Clarke <ku8ejeff@mediacombb.net> wrote:
> Did anyone else notice there were again a lot of DX stations that weren't
> signing their calls for a long period of time? You can directly attribute
> this to packet spotting. For those who operate this way, don't you realise
> you are hurting yourself? Your dupe rate will be high. Also casual
> participants will just give up and move on if you never say your call.
>
> As far as finding a run frequency as a little gun... My station is
> probably smaller than most of you. I don't even have a tower or any beams,
> just a collection of wire dipoles and loops in the trees. I will admit it's
> hard to find a run frequency on SSB but I've never had any problems finding
> a clear frequency high in the band's on CW. I've had many 100+ hours to EU
> up high. I have been doing HP lately since I bought a KPA500 last year but
> I've done it LP as well. Even made the top ten LP on CW a couple times with
> my peanut whistle station. If I can do it I bet all you fellow "little
> guns" with a simple tribander beam and wires can do this too.
>
> Jeff KU8E
>
> Sent from my Verizon Wireless 4G LTE Droid
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|