load digi.exe instead of any other driver you may have for the
card. then start ct with the -digi switch. all 8 com port
selections then go out the digiboard. unfortunately i don't
think you can use normal com1/com2 type ports or the nettsr at
the same time as the digiboard, but i haven't had my old digiboard
in since i set up the network.
Dan Szymanski wrote:
>
> I came up with a eight port digi board. PC/X series. Uses a fossil
> driver that loads from autoexec.bat file. Machine I am using is a
> Native DOS 6.22 only unit no WINDOZE installed at all. Machine is
> 486DX2-66, 16 MB RAM. This machines primary use is to run CT for
> contests. Also I have K1TTT's NETTSR loaded and running networked on a
> Intel NIC card to other native DOS only units.
>
> Other DOS comm programs like Telix and Timeset have been successfully
> reconfigured using a port on the Digi board for modem.
>
> Since it is rather poorly detailed, can anyone provide some guidance as
> to other than loading the DIGI.EXE TSR and using the command switch
> -digi within CT.exe what it takes to get this combination flying with
> the com ports? Ports I would to use include TNC, Radio1 and Rotor1.
> --
> Thanks in advance for your assistance.
>
> Regards,
>
> Dan Szymanski
> K3SKE
> Frederick, MD
> Potomac Valley Radio Club
> National Capital DX Association
>
> ------------------------------------------------------------------------
>
> Dan@erols <daniel.szymanski@erols.com>
>
> Dan@erols
> <daniel.szymanski@erols.com>
> Netscape Conference Address
> Netscape Conference DLS Server
> Additional Information:
> Last Name
> First Name Dan@erols
> Version 2.1
--
David Robbins K1TTT (ex KY1H)
k1ttt@berkshire.net or robbins@berkshire.net
http://www.berkshire.net/~robbins/k1ttt.html
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|