Finally trying to computerize and have the following problem:
Win95 with a 4 port add-on serial card providing ( COM 3 through COM 6).
FT-920 on COM 2, 4800-baud
Orion M2 on COM 3 9600-baud
Have keyer interface (from CT manual) connecting COM 4 to rig.
Rig control and rotor control work OK through DX4WIN logging software.
CT 9.44 is configured for radio and rotor as above. COM 3 through COM 6 are
all IRQ7 and COM 4 is set to I/O address 3E0. The manual says use a -3
command line switch for address 3E0, but the web site says use -2 switch.
It also mentions -XT and -SHARED command line switches.
Radio, rotor or CW interface/communications are not working. There are NO
addressing or IRQ conflicts. Suggestions? Thanks
Mark
mailto:mendorf@isd.net
--
WWW: http://www.k1ea.com/
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
Problems: owner-ct-user@contesting.com
|