CT-User
[Top] [All Lists]

[ct-user] Question on setting up a Yaesu 857 using N1MM

To: CT Contest Program Discussion List <ct-user@contesting.com>
Subject: [ct-user] Question on setting up a Yaesu 857 using N1MM
From: Al - N1API <n1api@cox.net>
Date: Tue, 08 May 2012 16:25:49 -0400
List-post: <ct-user@contesting.com">mailto:ct-user@contesting.com>
Well this may not be exactly the correct place to ask this, but I am 
trying to set an Yaesu 857D up for radio control with the N1MM Contest 
program.

I have a cable which terminates in a three pin plug on one end and is 
wired for the data jack on the other.  It is used with either the West 
Mountain RIGTALK or you can plug it into the Plug and Play.  I do have 
the Plug and Play but it seem that N1MM will not address the data of the 
Plug and Play because it also has to address the CW and Digital through 
the same comport.

I am trying to set it up though the USB port renumbered to COM 5 with 
the USB RIGTALk and can get it working somewhat, but when I change bands 
it will end up getting the wrong band data and show on a completely 
different frequency than the radio is on.  So it looks like the two are 
not taking to each other correctly.

Anyone set one up, if so how did you do and and also what Parameters did 
you use for the port configuration, IE Speed, Parity, Databits, Stop 
BIts, DTR, RTS, ECT.

Please reply off list.  Any help appreciate.

Thanks

Al  N1API

_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web:  http://www.k1ea.com/

<Prev in Thread] Current Thread [Next in Thread>
  • [ct-user] Question on setting up a Yaesu 857 using N1MM, Al - N1API <=