To: | tony@demarctech.com |
---|---|
Subject: | [Karlnet] 200mW card |
From: | John Tully <tully@mt.lv> |
Reply-to: | karlnet@WISPNotes.com |
Date: | Wed, 22 May 2002 18:29:26 +0300 |
List-post: | <mailto:karlnet@WISPNotes.com> |
Hello Tony, This is cut and past from the wispnotes list. I think you can see there is real improvement and our supplier has assured us that it is 200mW output. > > We have been swapping an Orinoco with with Prism 200 mW in Turbocell > > base--both seem to run fine, the Prism does help signal but not > > substantially (since YDI power amp is installed to boost signal, and > > it will clip if overdriven). > > > > The Prism card noticably improves the equation on the CPE end. Earlier > > > in the week we tested the Orinoco and the Prism using the same > > antennas (8dbi Patch and 13 dbi Yagi). The Prism is working > > substantially better--stronger signal and better readings (especially > > with the 8 dbi patch). > > > > A lot of this signal measurement was in 802.11b mode (but not all). > > Some was in TC. I'll publish numbers soon. > > > > Bottom Line: We haven't seen any problems yet w/200 mW and they have > > an FCC number on the card. We intend to continue testing over the > > weekend. > > > > Barry Whitcomb > > Quantum Success, Inc. / All Clear > > 265 Paces Lakes Drive > > Dallas, GA 30157 > > 770-505-1896 > > F: 770-234-5334 Sincerely, John Tully |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | RE: [Karlnet] 200mW cards in question, Roger Boggs |
---|---|
Next by Date: | RE: [Karlnet] In Errors/FCS Errors, Dan Metcalf |
Previous by Thread: | [Karlnet] 200mW card, John Tully |
Next by Thread: | RE: [Karlnet] In Errors/FCS Errors, Dan Metcalf |
Indexes: | [Date] [Thread] [Top] [All Lists] |