On Friday, October 31, 2003, Ben Polson wrote:
> Thanks much Slobodan! But when I use the .1.7.1 and .1.8.1 with snmpget,
> they always return a value of 0. What is different in the MRTG? I also
> don't see what the remote station is within the config you have below.
This is used on the remote station, assuming it only has a single WiFi
interface.
If you wanted to measure on the base station, you would have to fetch
the whole SNMP table with signal, noise and MAC address in rows, then
parse to match.
Regards, Slobodan
--
Slobodan Popovic
tehnicki direktor
Centar za razvoj Interneta
Masarikova 5/712
11000 Beograd, Srbija
Tel: (011) 3061-532
Fax: (011) 3061-554
Eml: spopovic@wireless.org.yu
|