Orion
[Top] [All Lists]

Re: [Orion] Firmware upgrade and CW/ACOM2000A issue again

To: n1eu@netscape.net (Barry N1EU), tentec@contesting.com,Orion@contesting.com
Subject: Re: [Orion] Firmware upgrade and CW/ACOM2000A issue again
From: "Sergei Kulyov" <ua3ap@smtp.ru>
Date: Sun, 05 Dec 2004 11:47:50 +0300
List-post: <mailto:orion@contesting.com>
Dear users:

I did open my ACOM (built in May '04). The mentioned
resistor was there. So I had to remove the recommended
capacitor and problem escaped!

I would like to thanks all who were trying to help,
especially - Bill, W4ZV.

73 from Moscow

Sergei UA3AP aka K3AO


On Sat, 04 Dec 2004 12:02:31 -0500
 n1eu@netscape.net (Barry N1EU) wrote:
> FWIW, I used to have the ARC fault problem a couple of
> years back with my FT-1000MP and Acom 2000A.  Piotr sent
> me scope photos of the timing problem with his Omni VI+
> and Acom back when he was troubleshooting the problem and
> best I could determine the same root cause was not the
> issue in my case.
> 
> I've used the v.1372 Orion in CQ WW CW (beta) and half of
> ARRL160 fairly intesively in qsk (keying loop) mode with
> zero delay without a single instance of ARC fault.  This
> doesn't mean to say that others might not benefit from
> applying Acom's mod (which I haven't done).
> 
> 73,
> Barry N1EU
> 
>
__________________________________________________________________
> Switch to Netscape Internet Service.
> As low as $9.95 a month -- Sign up today at
> http://isp.netscape.com/register
> 
> Netscape. Just the Net You Need.
> 
> New! Netscape Toolbar for Internet Explorer
> Search from anywhere on the Web and block those annoying
> pop-ups.
> Download now at
> http://channels.netscape.com/ns/search/install.jsp
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion

_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion

<Prev in Thread] Current Thread [Next in Thread>