RFI
[Top] [All Lists]

Re: [RFI] Excellent RFI notes by ON4WW

To: <jim@audiosystemsgroup.com>, <rfi@contesting.com>
Subject: Re: [RFI] Excellent RFI notes by ON4WW
From: "Wes Attaway \(N5WA\)" <wesattaway@bellsouth.net>
Date: Mon, 27 Dec 2010 20:18:33 -0600
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
I think Jim's explanation of this is very good.  It is clear and to the
point.  It should give the tinkerers in the crowd a lot of food for thought.

------------------ Wes Attaway (N5WA) ------------------
1138 Waters Edge Circle - Shreveport, LA 71106
    318-797-4972 (office) - 318-393-3289 (cell)
        Computer Consulting and Forensics
-------------- EnCase Certified Examiner ---------------
 

-----Original Message-----
From: rfi-bounces@contesting.com [mailto:rfi-bounces@contesting.com] On
Behalf Of Jim Brown
Sent: Monday, December 27, 2010 6:54 PM
To: rfi@contesting.com
Subject: Re: [RFI] Excellent RFI notes by ON4WW

On 12/27/2010 4:14 PM, Jimk8mr@aol.com wrote:
> The transmitter section was being grossly overloaded
> with  HF RF from 20 meters, causing it to put out RF garbage at who knows
> where!

Great story!  Many thanks.

One thought, however.  I STRONGLY object to use of the word "overload" 
to describe every case of RFI to equipment, because it's 
counterproductive. That is, it doesn't get interference fixed, because 
it doesn't get to the fundamental circuit mechanisms that couple RF into 
the circuitry that generates (or detects) the trash.

In fact, most RFI detection is NOT caused by overload of a gain stage, 
but rather by simple detection in the non-linearity at the turn-on 
corner of a semiconductor junction somewhere in the signal chain!  It 
takes a LOT more signal to overload that gain stage.

So back to those coupling mechanisms, which are 1) Pin 1 Problems in the 
equipment (that is, mis-termination of cable shields); 2) Poor shielding 
of equipment, and poor circuit board layout within equipment;  3) poor 
shielding of interconnect wiring;  4) Use of untwisted wiring for signal 
conductors 5) excessive bandwidth (or inadequate bandwidth limiting) of 
inputs and outputs.

My guess is that the dominant coupling was common mode, exciting #1. If 
that's true, it could probably be killed with a multi-turn ferrite choke 
on one or more of the leads going to that XM rcvr.

BTW -- your technique of reducing TX power to find out how much 
attenuation it takes to get rid of the interference is a VERY good one 
-- it tells you that you need at least 16dB of suppression at the victim 
device to kill the interference.

73, Jim K9YC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>