You've gotten good advice so far. If RFI ingress is occurring on the input
to a PC *power-amp* speaker system, then probably the most effective and
least invasive way to mitigate the common mode current is to wrap several
turns of the input cable through #31 mix ferrite cores. Wrap as close as
possible to the PC speaker's amplifier input. It's the *turns count* that
adds series common mode impedance. Have a look at K9YC's materials in the
link below. For several mix types, he shows the number of turns required to
achieve a target choking impedance for a given frequency.
http://audiosystemsgroup.com/RFI-Ham.pdf
Paul, W9AC
-----Original Message-----
From: Tony
Sent: Tuesday, June 30, 2015 8:08 PM
To: rfi@contesting.com
Subject: [RFI] PC Speaker "Buzz"
All:
What is the best method of reducing RF getting into ones PC speakers? Is
it best to use ferrite beads and toroids in mix 31, 43 or a combination
of both?
Thanks
Tony
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|